Gency key, a #2 flat blade screwdriver, or a coin and gently pry the two halves of the key fob apart. Make sure not to damage the seal during removal.ġ - Emergency Key Release Button 2 - Emergency Keyģ. Remove the battery by turning the back cover over Latch on the back of the key fob sideways with your thumb and pull the emergency key out with your other hand.Ģ. Separate the key fob halves using the tip of the emer. Do not touch the battery terminals that are on the backġ. Remove the emergency key by sliding the mechanical.Perchlorate Material - special handling may apply. See.The recommended replacement battery is one CR2032 battery. Replacing The Battery In The Key With Remote Control If one or more doors are open, or the liftgate is open, the doors will lock. The doors will unlock again automatically if the key is left inside the passenger compartment, other- wise the doors will stay locked. If the vehicle is equipped with Passive Entry, refer to “Keyless Enter-N-Go - Passive Entry” located in “Doors” in “Getting To Know Your Vehicle” for further information. The turn signal lights will flash and the horn will chirp to acknowledge the signal. Refer to “Uconnect Settings” located in “Multimedia” for further programmable infor- mation. Push and release the lock button on the key fob to lock all doors and liftgate. To “Keyless Enter-N-Go - Passive Entry” located in “Doors” in “Getting To Know Your Vehicle” for further information. If the vehicle is equipped with Passive Entry, refer This feature lets you program the system to unlock either the driver’s door or all doors on the first push of the unlock button on the key fob. To change the current setting, refer to “Uconnect Settings” in “Multimedia” for further infor- mation. The turn signal lights will flash twice to acknowledge the unlock signal. The illuminated entry system will be acti- vated. Is opened within 60 seconds, the vehicle will re-lock and if equipped, the security alarm will arm. If the vehicle is unlocked by a key fob, and no door Push and release the unlock button on the key fob once to unlock the driver’s door or twice within five seconds to unlock all doors and the liftgate.Īll doors can be programmed to unlock on the first push of the unlock button. Refer to “Uconnect Settings” in “Multi- media” for further information. In case the ignition switch does not change with the push of a button, the key fob may have a low or fully depleted battery. A low key fob battery can be verified by referring to the instrument cluster, which will display directions to follow.